ge-interlogix simon 3 ユーザーズマニュアル
Simon Security System
10
Figure 3. Panel Mounting Hole Locations
4.
For wall mounting, insert anchors into holes where studs are not present.
5.
Install all screws and tighten gently.
Connecting Hardwire Devices
The panel has 5 screw terminals located on the upper-right corner of the circuit board
(see Figure 3) for connecting AC power, sirens and/or hardwire detectors.
(see Figure 3) for connecting AC power, sirens and/or hardwire detectors.
AC Terminals
Note
All inputs and outputs are
Class II power limited cir-
cuits.
All inputs and outputs are
Class II power limited cir-
cuits.
These terminals are used for connecting a 9 VAC, 700 mA AC power transformer. For
systems with no X10 modules, use transformer part no. 22-109. For systems with X10
modules, use transformer part no. 22-TBD.
systems with no X10 modules, use transformer part no. 22-109. For systems with X10
modules, use transformer part no. 22-TBD.
HWIN1, HWIN2, and DCOUT Terminals
These terminals are dual purpose and can be used for either siren or hardwire detector
connections.
connections.
Note
These terminals cannot pro-
vide both functions simulta-
neously.
These terminals cannot pro-
vide both functions simulta-
neously.
Sirens
From the factory, these terminals are set up for siren operation with HWIN1 handling
interior sirens (status and alarm sounds), HWIN2 handling exterior sirens (alarm
sounds only), and DCOUT providing the positive (+) voltage.
interior sirens (status and alarm sounds), HWIN2 handling exterior sirens (alarm
sounds only), and DCOUT providing the positive (+) voltage.
Note
The total current available
from the DCOUT terminal is
250 mA at up to 122° F (50°
C).
The total current available
from the DCOUT terminal is
250 mA at up to 122° F (50°
C).
With Option 53: Hardwire Siren Supervision turned on, sirens connected to HWIN1
and HWIN2 are supervised and require a 4.7k resistor in the circuit. If either of these
terminals is not used with Option 53 on, you must connect a 47k resistor between the
unused terminal and DCOUT.
and HWIN2 are supervised and require a 4.7k resistor in the circuit. If either of these
terminals is not used with Option 53 on, you must connect a 47k resistor between the
unused terminal and DCOUT.
Hardwire Detectors
To set up HWIN1 and/or HWIN2 for hardwire detectors, make the required connec-
tions as described under “Wiring Hardwire Detectors,” then proceed to the “Program-
ming” section to add (learn) them into panel memory.
tions as described under “Wiring Hardwire Detectors,” then proceed to the “Program-
ming” section to add (learn) them into panel memory.
Wiring Interior Sirens
Panel terminal HWIN1 can be used for connecting interior sirens and activates for sta-
tus and alarm sounds.
tus and alarm sounds.
Mounting
Holes