Panasonic KX-HNS101 操作ガイド
3
Registration
Required only if the window/door
sensor was purchased separately
(i.e., not as part of a bundle).
Required only if the window/door
sensor was purchased separately
(i.e., not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Temporary placement
Temporarily place the window/
door sensor in the desired location
and confirm that it operates
properly (page 11).
Temporarily place the window/
door sensor in the desired location
and confirm that it operates
properly (page 11).
6
Installation
Install the window/door sensor on
the same position where proper
operation was confirmed
(page 14).
Install the window/door sensor on
the same position where proper
operation was confirmed
(page 14).
Inserting the battery
R USE ONLY a CR2 Lithium battery.
R Confirm the polarities (
R Confirm the polarities (
,
).
1
Remove the sensor unit cover.
R Lift from the indented area (A)
R Lift from the indented area (A)
and open the sensor unit cover
(B).
(B).
1
2
2
Insert the battery.
3
Attach the sensor unit cover.
Registering the
window/door sensor
This procedure is not required for
devices that were included as part of
a bundle.
devices that were included as part of
a bundle.
Before you can use the window/door
sensor, it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
sensor, it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
the registration buttons or the [Home
Network] app.
Using registration buttons
1
1
Hub:
Press and hold M
Press and hold M
OTHER
DEVICEN until the LED indicator
blinks slowly in green.
blinks slowly in green.
2
Window/door sensor:
Remove the sensor unit cover and
press and hold M
Remove the sensor unit cover and
press and hold M
N until the
LED indicator blinks slowly in
green (page 8).
green (page 8).
For assistance, please visit http://shop.panasonic.com/support
9
Setup
HNS101_(en_en)_0120_ver201.pdf 9
2017/01/23 15:42:25