Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY 仕様ガイド

Installing Network Modules in Cisco 2800 Series Routers

OL-5790-01

Installing Slot Dividers in Network Module Slots

In a Cisco 2851 router, you can install a slot divider in the network module slot to reduce the slot width
from extended double-wide to extended single-wide. Use of a slot divider alone (without a filler panel)
creates a slot width suitable for an enhanced extended single-wide (NME-X) network module. Use of a
slot divider with a filler panel creates a slot width suitable for an enhanced single-wide (NME) or older
version (NM) single-wide network module.

Figure 1

shows a slot divider with captive screw for the network module slot in Cisco 2851 routers.

Figure 1

Slot Divider for Network Module Slots

Install slot dividers into network module slots as follows:

Step 1

Insert the top rails of the slot divider between the two guide rails in the top of the network module slot.
See

Figure 2

Figure 2

Inserting a Slot Divider into a Network Module Slot

Step 2

Push the slot divider in until it is fully seated.

Step 3

Tighten the retention screw on the front of the slot divider with a number 1 Phillips screwdriver. See

Figure 3

. When the slot divider is fully inserted, its front surface is flush with the panel of the router.

See

Figure 4

121062

117050

T
D
M
0

A= A

GE 0

PVD

AIM

GE 0

S= S

PEE

A= F

A= LIN

S
L
O
T
2

S
L
O
T
0

S
L
O
T
3

S
L
O
T
1