Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY 仕様ガイド

The 

 section of the 

 online document

If there are internal FRUs to be removed or installed, perform the installation or removal before you 
install the chassis in a rack on a wall. To remove internal FRUs, you have to remove the chassis cover; 
this requires removal of the chassis from the rack.

If the required internal FRUs are already installed, proceed to the next section, 

.

Cisco 2800 series routers are normally ordered with modules and interface cards preinstalled. Before you 
remove or install any modules or interface cards, see the documents that accompany those items or to 
the online Cisco 2800 series hardware installation documentation at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/2800/hw/index.htm

 

For module and interface card compatibility information, see the data sheet for each module and 
interface card.

Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. 
Statement 1

You can set any Cisco 2800 series router on a desktop or install it in a rack. A Cisco 2811 router can also 
be mounted on a wall or other flat surface. See the applicable instructions in the following sections.

To prevent damage to the chassis, never attempt to lift or tilt the chassis by the plastic panel on the front. 
Always hold the chassis by the metal body.

If you are planning to rack-mount the router, do so before making network and power connections. If 
you need to install network modules or interface cards, you can do so either before or after 
rack-mounting the router. Ideally, you would install modules and interface cards when you have the best 
access to the rear panel of the router. Internal modules, such as advanced integration modules (AIMs) or 
packet voice data modules (PVDMs), should be installed prior to rack-mounting.