Avaya 4690 IP CONFERENCE PHONE WITHOUT MICS 仕様ガイド
Basic Troubleshooting Chart
Issue 2.0 February 2006
23
Resetting and Power Cycling the IP Conference Telephone
Reset your IP Conference Phone when other troubleshooting suggestions do not
correct the problem or after being advised to do so by your system administrator.
correct the problem or after being advised to do so by your system administrator.
This basic reset procedure can resolve most problems.
1. Press the Mute button
2. Using the dial pad, press the following keys in sequence: 73738#
The display shows the message “Reset values? *=no #=yes”
3. Press * (asterisk) or press # (the pound key):
4. Press # to restart the phone or * to terminate the restart and restore the
phone to its previous state
NOTE:
Restarting the telephone can take a few minutes.
If the reset procedure cannot be performed or does not solve the problem, and
your system administrator approves, the phone can be power cycled.
your system administrator approves, the phone can be power cycled.
■
To power cycle the phone, unplug the phone then plug it back in.
The phone reconnects and reinitializes.
NOTE:
It might take a few minutes before the phone can be used again.
If you want to
Then
Reset the phone without resetting
any assigned values
any assigned values
Press * (asterisk). The display
prompts “Restart phone? *=no
#=yes”
prompts “Restart phone? *=no
#=yes”
Reset the phone and any
previously assigned
(programmed) values.
previously assigned
(programmed) values.
(Use this option only if your phone
has programmed, static values.)
has programmed, static values.)
Press # (the pound key). The
display prompts “Are you sure?
*=no #=yes”. If yes the display then
prompts “Restart phone? *=no
#=yes”. The display shows the
message “Resetting values” while
your conference phone resets its
programmed values, such as the IP
address, to its default values, and
reestablishes the connection to the
server.
display prompts “Are you sure?
*=no #=yes”. If yes the display then
prompts “Restart phone? *=no
#=yes”. The display shows the
message “Resetting values” while
your conference phone resets its
programmed values, such as the IP
address, to its default values, and
reestablishes the connection to the
server.