Cisco CATALYST 6509E 9 SLOT 15U CHASSIS NO POWER SUPPLY NO FAN TRAY 仕様ガイド
4-3
Catalyst 6500 Series Switches Installation Guide
OL-5781-04
Chapter 4 Removal and Replacement Procedures
Removing and Installing the AC-Input Power Supplies
Removing a 950 W or 1400 W AC-Input Power Supply
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use
caution when servicing. Statement 1034
caution when servicing. Statement 1034
Note
In systems with redundant power supplies, you can replace the faulty supply while the system is
operating.
operating.
Note
This procedure covers the removal of the power supply only. For information on removing the power
entry module (PEM), see the
entry module (PEM), see the
Follow these steps to remove a power supply:
Step 1
Turn the power switch to the Off (0) position on the PEM for the power supply that you are removing.
(
(
shows the location of the AC-input PEMs on the Catalyst 6503 and Catalyst 6503-E switch
chassis.)
Step 2
Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord
when it is still connected to the PEM.
when it is still connected to the PEM.
Step 3
Remove the power cord from the power connection on the PEM. Do not touch the metal prongs
embedded in the PEM.
embedded in the PEM.
Step 4
Loosen the captive installation screws on the power supply. (See
for the Catalyst 6503
and 6503-E switches.)
Step 5
Grasp the power supply handle with one hand, and slide the power supply part of the way out of the
chassis. Place your other hand underneath the power supply, as shown in
chassis. Place your other hand underneath the power supply, as shown in
, and slide the power
supply completely out of the chassis.
Step 6
If the power supply bay is to remain empty, install a blank power supply filler plate (Cisco
part number 800-16727-01 for the Catalyst 6503 and Catalyst 6503-E switches) over the opening, and
secure it with the captive installation screws.
part number 800-16727-01 for the Catalyst 6503 and Catalyst 6503-E switches) over the opening, and
secure it with the captive installation screws.