Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 仕様ガイド

Using the Flash Disk

document for information about formatting a Flash Disk for the RSP16, installation procedures, and
other usage and upgrade information.

Two asynchronous serial ports on the RSP16, labeled Console and Auxiliary, allow you to connect
external terminal devices to monitor and manage the system. The console port is an Electronics
Industries Association/Telecommunications Industry Association (EIA/TIA)-232 receptacle (female)
that provides a data circuit-terminating equipment (DCE) interface for connecting a console terminal.

EIA/TIA-232 was known as recommended standard RS-232 before its acceptance as a standard by the
Electronic Industries Association (EIA) and Telecommunications Industry Association (TIA).

The auxiliary port is an EIA/TIA-232 plug (male) that provides a data terminal equipment (DTE)
interface; the auxiliary port supports flow control and is often used to connect a modem, a channel
service unit (CSU), or other optional equipment for Telnet management.

Normal

1

1.

The RSP16 controls these LEDs and turns them on in parallel to indicate that the system is operational.

Green

On

RSP16 is on and receiving +5V.

CPU halt

Green

Yellow

Off

On

RSP16 is operating normally.

Processor hardware failure has been detected.

Active

Green

On

RSP16 is an active RSP.

Standby

Green

On

RSP16 is a standby (HSA/HA configuration required).

Slot 0

Green

On

Flash Disk in this slot is being accessed.

Slot 1

Green

On

Flash Disk in this slot is being accessed.