JL Audio Stealthbox® オーナーマニュアル
Continued on Next Page
SB-B-X5E70/10W3v3 INSTR_SKU# 011324
S T E P 7
Remove the speed clip from the location indicated by the
left arrow, and relocate it to the location indicated by the
right arrow, as shown.
Remove the speed clip from the location indicated by the
left arrow, and relocate it to the location indicated by the
right arrow, as shown.
S T E P 6
Using a 1” hole saw, drill a hole at the intersection, and slide
a U-Nut through the drilled hole, aligning it with the factory
hole, as shown.
Using a 1” hole saw, drill a hole at the intersection, and slide
a U-Nut through the drilled hole, aligning it with the factory
hole, as shown.
S T E P 5
Note: Steps 5-6 are only necessary on vehicles not
equipped with the factory bracket shown in Step 4.
Note: Steps 5-6 are only necessary on vehicles not
equipped with the factory bracket shown in Step 4.
Locate the two holes in the floor, and mark their
perpendicular intersection, as shown.
perpendicular intersection, as shown.
S T E P 4
Remove the nut from the factory bracket, as shown. Retain
the nut for use in Step 10.
Remove the nut from the factory bracket, as shown. Retain
the nut for use in Step 10.
If this factory bracket isn’t present, substitute Steps 5-6.
Page 2 • JL Audio, Inc 2011
S T E P 9
Using a pair of 1/4” - 20 x 1” Bolts, 1/4” Lock Washers, and 1/4”
Flat Washers, attach the Side Bracket to the Stealthbox® as
shown, and hand tighten.
Using a pair of 1/4” - 20 x 1” Bolts, 1/4” Lock Washers, and 1/4”
Flat Washers, attach the Side Bracket to the Stealthbox® as
shown, and hand tighten.
S T E P 8
Pictured is the included hardware, along with the factory nut
removed from Step 4.
Pictured is the included hardware, along with the factory nut
removed from Step 4.
S T E P 1 0
Attach speaker cable to the Stealthbox®, and place the
enclosure into position, aligning the hole in the Side Bracket
with the factory bolt, as shown. Secure the Side Bracket to
the floor using the factory nut removed in Step 4.
Attach speaker cable to the Stealthbox®, and place the
enclosure into position, aligning the hole in the Side Bracket
with the factory bolt, as shown. Secure the Side Bracket to
the floor using the factory nut removed in Step 4.
On vehicles not equipped with the factory bracket and bolt,
secure the Side Bracket to the U-Nut installed in Step 6 using
a 1/4 - 20 x 1-1/2” Bolt.
secure the Side Bracket to the U-Nut installed in Step 6 using
a 1/4 - 20 x 1-1/2” Bolt.
S T E P 1 1
Slide the Stealthbox® as far back toward the rear of the
vehicle as possible. Using an open-ended wrench, tighten
the two 1/4” - 20 x 1” to secure the Side Bracket to the
Stealthbox®.
Slide the Stealthbox® as far back toward the rear of the
vehicle as possible. Using an open-ended wrench, tighten
the two 1/4” - 20 x 1” to secure the Side Bracket to the
Stealthbox®.