DJI Phantom 3 Standard (Factory Refurbished) オーナーマニュアル
10
©
2015 DJI. All Rights Reserved.
Aircraft
LED Indicators
The Phantom 3 Standard has two Front LEDs located under the two front motors and two Aircraft Status
Indicators located under the two rear motors.
The Front LEDs glow solid red when the aircraft is turned on and help you orientate the aircraft when it
is in the air. You can switch off the Front LEDs in the DJI GO app to achieve a better filming result. The
Aircraft Status Indicators indicate the status of the flight controller. See the table below for details of its
blinking patterns.
Aircraft
Flight Controller
The flight controller provides stability, safety and control to the Phantom 3 Standard. The supported flight
modes are designed to optimize aircraft control for different conditions and purposes. The flight controller
allows the aircraft to automatically Return-to-Home (RTH) if the remote controller signal is lost (i.e. Failsafe
RTH) or when instructed to by the pilot (i.e. Smart RTH), ensuring the safe return of your aircraft. Flight
data is stored to the device every time you fly and can be accessed anytime.
Flight Modes
Three flight modes are available. The details of each flight mode are found below:
P-Mode (Positioning): P-Mode works best when the GPS signal is strong. One of its two states will be
P-Mode (Positioning): P-Mode works best when the GPS signal is strong. One of its two states will be
selected by the aircraft automatically depending on GPS signal strength.
P-GPS: GPS is available. The aircraft uses GPS for positioning.
P-ATTI: GPS is not available. The aircraft only uses its barometer to maintain altitude.
A-Mode (Attitude): GPS is not used for positioning, and the aircraft only uses its barometer to maintain
altitude. If a GPS signal is present, the aircraft will still return to the last recorded Home Point if the remote
controller signal is lost.
F-Mode (Function): Intelligent Orientation Control (IOC) is supported in this mode. Refer to the IOC section
F-Mode (Function): Intelligent Orientation Control (IOC) is supported in this mode. Refer to the IOC section
in the Appendix for more information.
The Flight Mode Switch is locked in P-Mode by default. To enable other flight modes, go to the DJI GO
app > Camera View > > Advanced Settings > Enable Multiple Flight Modes.
The Flight Mode Switch is locked in P-Mode by default. To enable other flight modes, go to the DJI GO
app > Camera View > > Advanced Settings > Enable Multiple Flight Modes.
Front LED
Aircraft Status Indicator