DJI Phantom 4 Advanced Quadcopter オーナーマニュアル

Aircraft

Phantom 4 Advanced / Advanced+ User Manual

Battery Protection LED Display

The table below shows battery protection mechanisms and corresponding LED patterns.

Battery Level Indicators while Charging

LED1 LED2 LED3 LED4 Blinking Pattern

Battery Protection Item

LED2 blinks twice per second

Over current detected

LED2 blinks three times per second Short circuit detected

LED3 blinks twice per second

Over charge detected

LED3 blinks three times per second Over-voltage charger detected

LED4 blinks twice per second

Charging temperature is too low

LED4 blinks three times per second Charging temperature is too high

After these issues are resolved, press the Power Button to turn off the Battery Level Indicator. Unplug the

Intelligent Flight Battery from the charger and plug it back in to resume charging. Note that you do not

need to unplug and plug in the charger in the event of a room temperature error; the charger will resume

charging when the temperature is within the allowable range.

DJI does not take any responsibility for damage caused by third-party chargers.

How to discharge your Intelligent Flight Battery:

Slow : Place the Intelligent Flight Battery into the Phantom 4’s Advanced / Advanced+ Battery

Compartment and turn it on. Leave it on until there is less than 8% of power left, or until the

battery can no longer be turned on. Launch the DJI GO 4 app to check battery levels.

Rapid : Fly the Phantom 4 Advanced / Advanced+ outdoors until there is less than 8% of power

left, or until the battery can no longer be turned on.