Comp X Security Products Inc 421860 ユーザーズマニュアル
Adjust Headlamp
NOTE
Headlamp adjustment can be performed without removing the
headlamp door (chrome ring).
headlamp door (chrome ring).
1.
Insert Phillips screwdriver between headlamp housing and
rubber gasket.
rubber gasket.
2.
See Figure 59. Adjust beam.
a.
Turn the vertical adjusting screw (3) to adjust head-
lamp vertically.
lamp vertically.
b.
Turn the horizontal adjusting screw (4) to adjust
headlamp horizontally.
headlamp horizontally.
TURN SIGNAL BULB REPLACEMENT:
BULLET STYLE
BULLET STYLE
1.
See Figure 62. Insert a coin or the blade of a small
screwdriver into the notch at the bottom of the lens cap.
Carefully twist until the lens cap pops out of the lamp
housing.
screwdriver into the notch at the bottom of the lens cap.
Carefully twist until the lens cap pops out of the lamp
housing.
2.
Push in bulb and rotate counterclockwise. Pull bulb from
socket.
socket.
3.
Inspect condition of electrical contacts in socket. If neces-
sary, clean with a small wire brush and electrical contact
cleaner.
sary, clean with a small wire brush and electrical contact
cleaner.
4.
Coat base of new bulb with ELECTRICAL CONTACT
GREASE (Part No. 99861-90).
GREASE (Part No. 99861-90).
5.
Orient index pins on new bulb with pin guides inside bulb
socket. Push bulb in and turn clockwise to lock in place.
socket. Push bulb in and turn clockwise to lock in place.
6.
Snap lens cap back into the lamp holder. Rotate lens to
position notch at bottom of lamp.
position notch at bottom of lamp.
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
7.
Turn ignition on and test for proper turn signal operation.
NOTE
If the turn signal or running lamp will not light after replacing a
bulb, check the wiring, the ground at the socket and/or the
switch.
bulb, check the wiring, the ground at the socket and/or the
switch.
168 Maintenance and Lubrication