Exegin Technologies Limited Q53 ユーザーズマニュアル

Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2009

viii. Reference Information
Complete Command Reference

Set commands

These commands alter the current or working settings in memory only. They will be lost
if the Q53 is turned off then on. To ensure this does not happen, be sure to issue a "

save

command so the current settings get written to Flash.

list [default|stored] radio

Lists the version, model number, RF
channel and receiver state for each Zigbee
radio in the Q53.

list [default|stored] snmp

List SNMP configuration.

list [default|stored] sysinfo

List the current Q53 system information
(e.g. contact name and protocol stacks
enabled).

list [default|stored] user

List the current user definitions (e.g. user
names and types).

list uptime

List the time the unit has been powered up
since the last power cycle. (e.g. "Uptime: 12
days, 22:50:23").

list [default|stored] zbmac

List all current Zigbee settings (e.g. RF
channel selections, PAN ID filter and
Extended Address Filters).

list zbnwk

Displays the current Zigbee network status,
including the MAC address, PAN ID,
Network Neighbour Table and Network
Routing Table.

list zbnwktest

Displays whether the Zigbee network test is
currently running, along with the test
results.

list zipt

Displays the host names of the remote
Zigbee bridge devices, as well as the UDP
port number used to transport Zigbee
messages over the IP network.

Table 5—Set Command Options

Command Syntax

Description

set sysinfo hostname hostname

Set a hostname for use with DDNS.

For example:

set sysinfo hostname

Q53Plan2

Table 4—List Command Options

Command Syntax

Description