Generac Power Systems 0G6019 ユーザーズマニュアル
4
INSTALLATION
For easier installation, the batteries should first be
fitted into the display unit (Figure 1). This will allow
you to walk around and find the best location for the
unit while still receiving good signal strength. Attach
the other transceiver to the generator and mount it as
high as possible, preferably away from any structures
to get a maximum signal.
fitted into the display unit (Figure 1). This will allow
you to walk around and find the best location for the
unit while still receiving good signal strength. Attach
the other transceiver to the generator and mount it as
high as possible, preferably away from any structures
to get a maximum signal.
Figure 1 — Open Display Unit
1. Insert the batteries (Figure 2).
Figure 2 — Insert Batteries
2. Connect the generator end transceiver and ensure
it is turned on.
3. IMMEDIATELY turn on the display, one minute
will pass while the generator tries to find it’s dis-
play.
play.
4. The display will show that it is searching for the
generator and the yellow LED may flash occasion-
ally as it receives data from the generator trans-
ceiver. This is due to the unit searching for the
correct channel.
ally as it receives data from the generator trans-
ceiver. This is due to the unit searching for the
correct channel.
5. Once the generator is found, the radio link is now
setup and the settings will be remembered next
time the display unit is turned on. If the genera-
tor is not found, an error message will briefly be
shown, and the yellow LED will flash at one (1)
second intervals to indicate the display unit was
unable to find the generator.
time the display unit is turned on. If the genera-
tor is not found, an error message will briefly be
shown, and the yellow LED will flash at one (1)
second intervals to indicate the display unit was
unable to find the generator.
6. If the battery power to the generator (and there-
fore the end transceiver) is ever disconnected, the
radio link will need to be reset. See the section
titled “Reset Radio”.
radio link will need to be reset. See the section
titled “Reset Radio”.
7. If the generator is not talking to it’s transceiver,
but the radios are talking to each other, this will
be indicated by an appropriate alarm which will
be displayed after a 30 second period. Check the
wiring and connection to the generator.
be indicated by an appropriate alarm which will
be displayed after a 30 second period. Check the
wiring and connection to the generator.
8. Place the display at the preferred location. Do not
permanently mount it yet.
9. Plug the wall transformer into the display so as
not to use up the batteries. Familiarize personnel
with the radio menu (by reading the manual in
conjunction with operating the display).
with the radio menu (by reading the manual in
conjunction with operating the display).
10. Navigate the display to show the “Radio
Information” screen from the radio menu.
11. Monitor the signal strength and relocate the dis-
play if the signal strength is poor or non existent.
The signal strength display is only updated if the
unit can communicate, (which occurs every two
(2) seconds), and will be set to display zero if the
unit cannot communicate within a ten (10) sec-
ond period.
The signal strength display is only updated if the
unit can communicate, (which occurs every two
(2) seconds), and will be set to display zero if the
unit cannot communicate within a ten (10) sec-
ond period.
12. Mount the display using the holes on the back to
hang onto two suitably sized fixing screws in the
drywall 2¼ inches apart. It should be vertically
mounted on a wall BETWEEN studs for maxi-
mum signal strength (Figure 3).
drywall 2¼ inches apart. It should be vertically
mounted on a wall BETWEEN studs for maxi-
mum signal strength (Figure 3).
Figure 3 — Mounting Holes
Wireless Display System