Autel Intelligent Tech. Corp. Ltd. MAXISYSMY908 ユーザーズマニュアル
General Introduction
VCI
– J2534 ECU Programming Device
9
1.
Ethernet Port
2.
USB Port
3.
Power LED - illuminates solid green when powered on
4.
Error LED - illuminates solid red when serious hardware failure occurs
5.
Bluetooth LED - illuminates solid green when connected with the
MaxiSys display tablet through Bluetooth communication
MaxiSys display tablet through Bluetooth communication
6.
Ethernet LED - illuminates solid green when connected with the MaxiSys
display tablet or an existing LAN via the Ethernet serial cable
display tablet or an existing LAN via the Ethernet serial cable
7.
USB Status Light -- illuminates solid green when the device is properly
connected and communicating with the MaxiSys display tablet or the PC
via the USB cable
connected and communicating with the MaxiSys display tablet or the PC
via the USB cable
8.
Vehicle LED - flashes green when communicating with the vehicle
’s
network
IMPORTANT: Do not disconnect the reprogramming device while this status
light is on! If the flash reprogramming procedure is interrupted while the
vehicle
light is on! If the flash reprogramming procedure is interrupted while the
vehicle
’s ECU is blank or only partially programmed, the module may be
unrecoverable.
9.
Bluetooth Antenna
10. DC Power Supply Input Port
11. Vehicle Data Connector (DB26-Pin MVCI)
12. External Programming Voltage Output Port
13. A/D Input Port
J2534 Reprogramming Capability
The J2534 ECU Programming Device is a SAE J2534-1 & -2 compliant
PassThru reprogramming interface device. Using the updated OEM software,
it is capable of replacing the existing software/firmware in the Electronic
Control Units (ECU), programming new ECUs and fixing software-controlled
drivability issues and emission issues.
PassThru reprogramming interface device. Using the updated OEM software,
it is capable of replacing the existing software/firmware in the Electronic
Control Units (ECU), programming new ECUs and fixing software-controlled
drivability issues and emission issues.
Communication
The J2534 ECU programming device supports Bluetooth, Ethernet and USB
communication. It can transmit vehicle data to the MaxiSys display tablet with
or without a physical connection. The working range of the transmitter through
Bluetooth communication is 755 feet (about 230 m). A signal lost due to
moving out of range automatically restores itself when the display tablet unit is
brought closer to the VCI unit.
communication. It can transmit vehicle data to the MaxiSys display tablet with
or without a physical connection. The working range of the transmitter through
Bluetooth communication is 755 feet (about 230 m). A signal lost due to
moving out of range automatically restores itself when the display tablet unit is
brought closer to the VCI unit.