Zonoff Inc. EMBY001 ユーザーズマニュアル

The Cooper Dimmer Series replaces regular switches and dimmers and provides ON/OFF/DIM/BRIGHT control locally and 
through TaHomA. Cooper Dimmers must be installed by a professional electrician as per the manufacturer’s instructions 
included with the device. As part of TaHomA’s Z-Wave mesh network, the dimmers will act as repeaters, ensuring 
commands will be transmitted regardless of obstacles or dead spots. 

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Make sure the dimmer correctly controls all attached connected loads before including into TaHomA. Verify that the 1st 

LED Level Indicator is blinking.

2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  Briefly press and release the ON/OFF switch. DO NOT press any other buttons at this time. The LEDs will stop blinking and

the 1st level LED will remain solid. Once the Device Finder window displays the message “Found a Device” and the 
Name and Room drop down menus appear, the dimmer has been successfully included into the TaHomA system. 

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA controller, in 
which case, you will have to use the USBIC for programming (refer to page 69 for more information about the USBIC).

4.  In the Device Editor window, enter a name for the dimmer and assign it to a room.

5.  The dimmer is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

dimmer through TaHomA’s Device Configurator to confirm successful programming.

1st LED Level Indicator is Blinking Blue: Device is not 
included in TaHomA. Once included, it will turn off.

LED ON/OFF Indicator: Indicates when connected lights 
have been activated.

LED Level Indicators are Blue: Indicate brightness of 
connected lights. 

Dimmers

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the ON/OFF switch. TaHomA will remove the dimmer from the system and the icon will

disappear from TaHomA. Once removed from the system, the 1st LED Level Indicator will start blinking, indicating the 
dimmer is no longer included in TaHomA.

ON/OFF: Pressing the ON/OFF switch will act as a toggle switch and turn connected lights ON or OFF.

TO BRIGHTEN/DIM: Press the top/bottom of the DIMMER button. Pressing and holding the bottom of the dimmer button will dim 
the lights all the way down, then turn them off.

Delay Off: With the connected light on, press and hold the ON/OFF button until the LED Level Indicator starts to blink. A 10 second 
countdown will begin. When the countdown is up, the dimmer will turn all connected lights off.

When you need to change a bulb connected to this dimmer, pull out the AIR GAP SWITCH. This will cut power to the dimmer and 
allow you to change the bulb. Push the switch back into place to resume normal control. 

Dimmers 

cont’d