Zonoff Inc. EMBY001 ユーザーズマニュアル

The Cooper Plug-In Appliance Module provides ON/OFF control for attached devices locally and through TaHomA. Once 
installed, lights can be dimmed to preset levels just like overhead lights as part of Scenes or as needed by the End User. 
Plugs into any 120V AC outlet. As part of TaHomA’s Z-Wave mesh network, the Plug-In Appliance Module will act as a 
repeater, ensuring commands will be transmitted regardless of obstacles or dead spots.

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Make sure the module is not included by confirming the Status LED is blinking amber.

2.  Ensure device to be plugged into module is functioning properly. Plug device into module.

3.  Plug the module into a live 120VAC wall outlet. If the outlet is controlled by a wall switch, the switch must be kept ON 

at all times. 

4.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

5.  Briefly press and release the CONTROL SWITCH. Once the Device Finder window displays the message “Found a Device”

and the Name and Room drop down menus appear, the module has been successfully included into the TaHomA 
system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC). 

600W Plug-In Appliance Module

LED is Blinking Amber: Device has power, but is not 
included in TaHomA. 

LED is Green: Connected load is turned ON.

LED is OFF: Connected load is turned OFF.

6.  In the Device Editor window, enter a name for the module and assign it to a room.

7.  The module is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

connected device through TaHomA’s Device Configurator to confirm successful programming.

NOTE: If the module is relocated while included in TaHomA, run “Rediscover Z-Wave Network” in TaHomA’s Device Configurator.
For more information on this feature, refer to the 

Advanced Features section of this guide.

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the CONTROL SWITCH. TaHomA will remove the module from the system and the icon will

disappear from TaHomA. Once removed from the system, the module’s LED will start blinking, indicating it is no longer 
included in TaHomA.

Pressing the top or bottom of the CONTROL SWITCH will turn connected lights ON and OFF.

Please be mindful when using TaHomA’s scheduling capabilities when managing unattended devices. 

600W Plug-In Appliance Module

 cont’d