Zonoff Inc. EMBY001 ユーザーズマニュアル

®

Wall Switches 

cont’d

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the ON/OFF SWITCH. TaHomA will remove the switch from the system and the icon will disappear

from TaHomA. 

Pressing the ON/OFF SWITCH will act as a toggle switch and turn connected loads ON or OFF.

The Leviton Dimmer Series replaces regular switches and dimmers to provide ON/OFF/DIM/BRIGHT control locally and through 
TaHomA. Leviton Dimmers must be installed by a professional electrician as per the manufacturer’s instructions included 
with the device. Alternate color plates are included in the package and can be switched as per the manufacturer’s included 
instructions. As part of TaHomA’s Z-Wave mesh network, the dimmers will act as repeaters, ensuring commands will be 
transmitted regardless of obstacles or dead spots.

NOTE: Only 1 device at a time can be included in TaHomA.

1.  Make sure the dimmer correctly controls all connected loads before including into TaHomA. 
2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a Device to Add to the Network” before continuing to the next step.

3.  Briefly press and release the ON/OFF SWITCH. Once the Device Finder window displays the message “Found a Device” and

the Name and Room drop down menus appear, the dimmer has been successfully included into the TaHomA system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

4.  In the Device Editor window, enter a name for the dimmer and assign it to a room. 

5.  The dimmer is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

dimmer through TaHomA’s Device Configurator to confirm successful programming.

LED Indicator is GREEN: Connected load is OFF. 

LED Indicator is OFF: Connected load is ON. 

LED Indicator is blinking AMBER: Dimmer is 
communicating with TaHomA.

LED Indicator is RED: Communication error. 

Dimmers