Zonoff Inc. EMBY001 ユーザーズマニュアル

EVOLVE™

6.  The module is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

connected device through TaHomA’s Device Configurator to confirm successful programming.

NOTE: If the module is relocated while included in TaHomA, run “Rediscover Z-Wave Network” in TaHomA’s Device 
Configurator. For more information on this feature, refer to the

Advanced Features section of this guide.

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the ON/OFF BUTTON. TaHomA will remove the device from the system and the icon will

disappear from TaHomA. 

ON/OFF: Pressing the ON/OFF BUTTON will act as a toggle switch and turn connected lights ON or OFF.

TO BRIGHTEN/DIM: Press and hold the ON/OFF BUTTON to bring lights to desired levels. 

300W Plug-In Dimming Module 

cont’d

Wall Switches

The Leviton Wall Switch Series replaces regular switches and dimmers to provide ON/OFF control locally and through TaHomA. 
Leviton Wall Switches must be installed by a licensed electrician following the instructions included with the device. 
Alternate color plates are included in the package and can be switched as per the manufacturer’s included instructions. 
As part of TaHomA’s Z-Wave mesh network, the switches will act as repeaters, ensuring commands will be transmitted 
regardless of obstacles or dead spots.

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Make sure the switch correctly controls all connected loads before including into TaHomA.
2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  Briefly press the ON/OFF SWITCH. Once the LED turns off and the Device Finder window displays the message “Found a

Device” and the Name and Room drop down menus appear, the switch has been successfully included into the TaHomA 
system. 

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

4.  In the Device Finder window, enter a name for the switch and assign it to a room.

5.  The switch is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

switch through TaHomA’s Device Configurator to confirm successful programming.

LED is SOLID GREEN: Connected load is OFF. 

LED is OFF: Connected load is ON.

LED is blinking AMBER: Switch is communicating with    
TaHomA.

LED is RED: Communication error.