Trackcom Limited DPU-4500 ユーザーズマニュアル

 

21 

 

4.1 Software 

Installation 

 
Insert Software CD into CD-ROM Drive. InfoTrack will automatically Run. 
Follow Installation Wizard to load Software. 
 
If CD fails to Automatically Run. 
Click the >Start< button on the task bar and choose >Run< and type <*> 
:/SETUP.EXE > OK 
 
You will be asked to insert an Activation Code which you can obtain by calling 
Trackcom Ltd. on 01908 288288, Quoting your System ID number.  
 
Your System ID number will displayed on the initial Unlock software Screen. 
 

 

5.1 Introduction 

 
The information in this section details most eventualities that will occur when 
commissioning a vehicle. When in doubt, the installer should contact Trackcom 
technical support on 00 (44) 1908 288288 which is manned between 0900 and 
1800 weekdays (UK time). 
 
Before the InfoTrack equipment is commissioned, the following requirements 
must be met: 
 
- Equipment correctly fitted in accordance to section 3 of this manual 
- Vehicle to be on a reasonable open site i.e. not garaged 
- Full set of testing equipment to be available 
- Tool kit available 
 
 

5.2 Testing 

equipment 

 
A laptop computer and modem complete with the InfoTrack programme and a 
digital multi-meter (DMM) must be available before attempting to commission the 
equipment.  
 

5.3 Commissioning 

procedure 

 
The following list shows the procedure to be followed for commissioning a 
vehicle. Each stage must have been passed before proceeding to the next stage.