Trackcom Limited DPU-4500 ユーザーズマニュアル
8
antenna(s) provided with this unit must be used. Do not use different
antennas(s) or cable. Doing so may result in the installed system exceeding
the RF exposure requirements. Further, the antennas must be installed
such that the minim distance of 20 cm away from all nearby person is
maintained.
antennas(s) or cable. Doing so may result in the installed system exceeding
the RF exposure requirements. Further, the antennas must be installed
such that the minim distance of 20 cm away from all nearby person is
maintained.
1.6 Covert antenna GSM/GPS
The covert antenna is designed to be used when the presence of an installation
needs to be hidden, and also eliminates the need to drill a hole in the vehicle
bodywork. The cabling for this antenna terminates with a male SMA connector for
GSM and a male SMC connector for GPS
needs to be hidden, and also eliminates the need to drill a hole in the vehicle
bodywork. The cabling for this antenna terminates with a male SMA connector for
GSM and a male SMC connector for GPS
1.7 Power
cable
The power cable is designed to connect both a permanent voltage to power the
DPU and to an ignition line to allow the full range of functionality of the unit to be
used.
DPU and to an ignition line to allow the full range of functionality of the unit to be
used.
2 Installation code of practice
2.1 Installation
C.O.P
The following code of practice lays down the criteria for InfoTrack dealers to
adhere to when installing the InfoTrack Vehicle Tracking system.
The objective of adherence to the code of practice is to ensure a satisfied
customer with a safe and efficient installation thus maintaining the high quality of
a system associated with the InfoTrack name.
adhere to when installing the InfoTrack Vehicle Tracking system.
The objective of adherence to the code of practice is to ensure a satisfied
customer with a safe and efficient installation thus maintaining the high quality of
a system associated with the InfoTrack name.
2.2 Approved
installers
A qualified installer using InfoTrack's recommended fitting instructions must fit all
DPU’s. Please contact InfoTrack for the current list of approved installers.
DPU’s. Please contact InfoTrack for the current list of approved installers.
2.3 Vehicle
inspection
Prior to installation the vehicle's bodywork, upholstery and electrical fittings shall
be checked. If any problems are identified these shall be pointed out to the
customer before the work takes place. The InfoTrack Pre-Installation (PI1) form
checklist shall be completed to provide a record of the vehicle condition before
installation, which is to be signed by the customer.
be checked. If any problems are identified these shall be pointed out to the
customer before the work takes place. The InfoTrack Pre-Installation (PI1) form
checklist shall be completed to provide a record of the vehicle condition before
installation, which is to be signed by the customer.