Vanu Inc. 0AD1C0010 ユーザーズマニュアル
ADCP-75-163SDR • Issue 1 • September 2004
Page 5
© 2004, ADC Telecommunications, Inc.
processing functions instead of using resistors, capacitors, feedback loops, or application-
specific integrated circuits.
specific integrated circuits.
The SDR PCIx host card is installed in a server and cabled to the LRCS remote (radio head)
units and the GPS receiver. Power is provided by the server with configuration and software
management through the server communications interface. Communications with the network
is through the server and associated hardware and software.
units and the GPS receiver. Power is provided by the server with configuration and software
management through the server communications interface. Communications with the network
is through the server and associated hardware and software.
2
SDR CARD INSTALLATION
2.1
Power Down the Server
1. Back up the server data.
2. Shut down the operating system as directed by the operating system documentation.
3. If the server is installed in a rack, locate the server.
4. Some servers may have a standby mode, if your server has a standby mode, press the
Power On/Standby button to place the server in standby mode. When the server activates
standby power mode, the system power LED should indicate the change to standby mode.
standby power mode, the system power LED should indicate the change to standby mode.
5. Disconnect the power cords. Server is now without power.
2.2
Extend Server from the Rack
Loosen the thumbscrews that secure the server faceplate to the front of the rack. Extend the
server on the rack rails until the server rail-release latches engage.
server on the rack rails until the server rail-release latches engage.
2.3
Remove Access Panel
Lift up on the hood latch handle and remove the access panel.
Warning: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On switch may
not completely shut off system power. Portions of the power supply and some internal circuitry
may remain active until AC power is removed.
remove the power cord to remove power from the server. The front panel Power On switch may
not completely shut off system power. Portions of the power supply and some internal circuitry
may remain active until AC power is removed.
Warning: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
Warning: To reduce the risk of personal injury, be careful when pressing the server rail-release
latches and sliding server into the rack. The sliding rails could pinch your fingers.
adequately stabilized before extending a component from the rack.
Warning: To reduce the risk of personal injury, be careful when pressing the server rail-release
latches and sliding server into the rack. The sliding rails could pinch your fingers.
Warning: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
internal system components to cool before touching them.
Caution: Do not operate the server for long periods without the access panel. Operating the
server without the access panel results in improper airflow and improper cooling that can lead
to thermal damage.
server without the access panel results in improper airflow and improper cooling that can lead
to thermal damage.