Vanu Inc. 0AD1C0010 ユーザーズマニュアル

ADCP-75-163SDR • Issue 1 • September 2004

Page 6
© 2004, ADC Telecommunications, Inc.

1. If necessary, disconnect any internal or external cables connected to all expansion boards.

2. Lift the PCI riser cage thumbscrews and turn them counter-clockwise.

3. Remove the PCI riser cage.

Most servers contain a PCI-X backplane that is part of the PCI riser cage. The PCI backplane
normally provides hot-plug capability to two expansion slots and a third non-hot-plug expansion
slot. SDR PCIx Host card is installed in the non-hot-plug PCI-X expansion slot that meets the
specification; 64-bit/133-MHz 3.3V. Determine which slot the SDR card is to be installed in and
remove the expansion slot cover.

1. Slip on an Electro-Static Discharge (ESD) wrist strap and connect the ground wire to an

earth ground source. Wear the ESD wrist strap while completing the SDR PCIx Host Card
installation procedure. 

2. Unlock the PCI retaining clip.

3. Install the card.

4. Lock the PCI retaining clip.

5. Power, network interface, and communications to the card are supplied through the card

edge connector.

1. Align the PCI riser cage with the chassis and slide it into place.

2. Tighten the screws to secure the PCI riser cage.

Caution:  To prevent damage to the server or expansion boards, power down the server and
remove all AC or DC power cords before removing or installing the PCI riser cage.

Caution: To prevent improper cooling and thermal damage, do not operate the server unless all
PCI slots have either an expansion slot cover or an expansion board installed.

Caution: Electronic modules can be damaged by electrostatic discharge (ESD). To prevent this,
take the following precautions:

Caution:  To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI riser cage.