GRAUPNER CO. LTD. 16007700 ユーザーズマニュアル

14 / 36

S1036.77_jh_V1_de

Interfaces
Provided connection 

On the left side is located the DSC socket. This socket allows 

the trainer/pupil function and the use of flight simulators.
For more information on the DSC socket and the trainer/pupil 

function see the section "DSC socket".

The card slot is suitable for micro SD memory card. For informa-

tion on removing and inserting the memory card, refer to the 

section "memory cards".

The ear phones port is suitable for a 3,5 mm jack. Though this 

interface both acoustic signals and voice messages are emitted.
The volume can be controlled by "Voice volume" and "Signal vol-

ume" in the general settings.

As soon as you connect the USB cable to the transmitter a 

selection menu appears.. Here you can set up the function of 

the micro USB port.
PC COM Port - for updates
Mass storage memory - to access to the SD card
Battery charge - only battery charging

Through the micro USB port you can charge the transmitter bat-

tery. Use the included USB cable to connect the transmitter to 

a suitable USB port and charge the transmitter battery. If the 

transmitter is switched on the charge time is longer than if the 

transmitter is switched off.
The maximum charge current is 2 A.
More information are available in the section "Charging the trans-

mitter battery".
Note
The HV-LiPo battery reaches its full capacity only when it is 

externally charged at 4.35V. The internal charging voltage is lim-

ited to 4.2 V for compatibility reasons.

USB connected
 



PC COM Port

   Mass storage
   Charge only