GRAUPNER CO. LTD. 16007700 ユーザーズマニュアル

21 / 36

S1036.77_jh_V1_de

On the upper side of the transmitter there is an eyelet which can 

be used to hook a neck-strap.

The transmitter should be opened only in the following cases:

 



If a self centering stick has to be converted in non self cen-

tering

 



If a non self centering stick has to be converted in self cen-

tering

 



To set the control stick centering force

Before opening the housing switch the transmitter off.
Open the battery case.
Remove the battery.
If the hand rests are installed: Loosen each of the three lower 

screws of the six fixing screws securing the hand pads.
Loosen the five case screws.
Hold both housing halves with both hands and let the screws 

fall on a proper surface turning the transmitter upside-down.
Rotate the lower case and lay it on one side.

Check if the upper and the lower part of the transmitter housing 

are correctly coupled.
Screw the housing screws in their original position.
Connect the battery.
Install the hand pads again.