GRAUPNER CO. LTD. 16007700 ユーザーズマニュアル
33 / 36
S1036.77_jh_V1_de
Update through USB port
Download the actual software package from the Internet, and
unpack it on your computer. Connect your switched off trans-
mitter with your PC, by using the included USB cable, which is
supplied with the package content, plug USB cable directly to
the micro USB port of the transmitter and the other end to a free
port in your computer. All other information can be found in the
instructions that come in the software package.
Problems during firmware update
Problem: POWER switch without function
If a firmware update for the transmitter is unsuccessful or the
If a firmware update for the transmitter is unsuccessful or the
transmitter program freezes and the transmitter cannot be
turned off using the "POWER" switch, then remove the transmit-
ter's battery after setting the switch to "POWER = OFF" position,
or pull the plug from the transmitter battery, reconnect it after
few seconds and leave the transmitter switched OFF.
Download the most recent update file from the Internet and save
Download the most recent update file from the Internet and save
the file in the “RECOVERY” folder in your SD card.
Then change the file name in “R260.bin”.
Insert the SD card in the transmitter.
Push and hold the Ctl 5 and Ctl 6 buttons at the same time to
Then change the file name in “R260.bin”.
Insert the SD card in the transmitter.
Push and hold the Ctl 5 and Ctl 6 buttons at the same time to
the top and push the Power button.
Now pull the Ctl 5 and Ctl 6 buttons within 2 - 3 sec. to you and
Now pull the Ctl 5 and Ctl 6 buttons within 2 - 3 sec. to you and
keep them in that position for about 10 sec.
Wait at least 30 sec. On the display there will be no image.
Wait at least 30 sec. On the display there will be no image.
During the update the transmitter cannot be switched on.
After 30 sec. switch the transmitter on.
After 30 sec. switch the transmitter on.