GRAUPNER CO. LTD. 16007700 ユーザーズマニュアル

32 / 36

S1036.77_jh_V1_de

Firmware update

The programs and files which are also required for updating the

transmitter combined into one software package can be down-
loaded from

www.graupner.de

Download this software package from the Internet, and unpack

it on your computer. All other information can be found in inter-

net in the same page where the software package is available.
Firmware updates of the transmitter can be performed in two

ways.

Update through memory card

Update through USB port

Note

Please note that compatible firmware is required for reliable
communication between the HoTT components. The programs
and files that are required to update are therefore combined into
a single file.

The current firmware version can be found on the Internet at
www.graupner.de.

Only operate your transmitter using the current software version.
these information can also be found at: www.graupner.de =>
Service & Support => Update and revision history for GRAUPNER
HoTT components.

Before each update, check the transmitter battery charge or

charge it as a precaution, and save all model memories so that

they can be restored if necessary.

Do not disconnect the link to the computer during an update!

Make sure that the link between the transmitter and computer is

operational.

After each update, check to make sure that the models function
correctly.

Update through memory card

Download the actual software package from the Internet, and

unpack it on your computer. Insert the supplied mini SD Card in

the card slot of your PC and copy the required firmware file from

the unpacked software package into the directory "Firmware“

on the memory card. Then, remove the memory card from the

PC and insert it in the card slot of the transmitter.

Switch on the

transmitter and the RF module off.
Go to the submenu "FIRMWARE UPDATE" in the menu "Hidden

mode" and proceed as described in the "Hidden mode" section.