GRAUPNER CO. LTD. 16007812 ユーザーズマニュアル

19 / 28

S1002.PRO_jh_V1

As soon as you connect the USB cable to the transmitter a selection 

menu appears.. Here you can set up the function of the micro USB 

port.

PC COM Port

Select this setting for updates with your PC.

Joystick

For use in a PC with a flight simulator. In this function the PC recog-

nizes the transmitter as a joystick. You can select the control area in 

the "Base settings" menu in the line "USBjoistick". The control travel 

can be set within 0 % and 100% or within -100% and +100%. The 

standard setting for the most flight simulators is 0% to 100%.

Battery charging

Battery charge only, no data transmission
In the upper right corner this indication shows a countdown, this is 

the time during which the indication is displayed. You can select 

through the arrow keys up and down.
You have two charge possibilities:

1. Removing the battery from its case and charging it with a char-
ger

Removing transmitter battery

Remove the battery case cover. Then remove and disconnect the 

battery plug by carefully pulling on the supply cable.
Charge the battery following the charger manual.

Inserting the transmitter battery

Connect the battery plug in the transmitter socket. Make sure that 

the polarity is correct. Pay attention to the respective "+" and "-" 

symbols near the socket.

Place the battery into its compartment and close the cover.

2. Through the USB port by charging with USB cable

The transmitter battery can be charged by the current supplied by 

the USB port (5 V/max. 0.5 A). The charging process is shown through 

the red lightning Graupner text. The indication quits when, with 

switched off transmitter, the battery is full.

USB connected     7
 PC COM Port
 Joystick
 



Battery charge

3

Signal volume

Back port

OHRH

DATA  sel.

Telemetry

DSC output

PPM12

USBjoystick

0~100