GRAUPNER CO. LTD. 16007812 ユーザーズマニュアル

17 / 28

S1002.PRO_jh_V1

Check if the upper and the lower part of the transmitter housing are 

correctly coupled and the tiny cables are properly placed.
Screw the housing screws in their original position.
Connect the battery holder.

Neutralizing the control sticks

Both control sticks can be set from neutralizing to non-neutralizing.

Locate in the left control stick gimbal the screw surrounded by a 

white circle in the picture.
Turn the screw toward the inside of the transmitter until the relevant 

control stick can move freely from stop to stop, or turn it outward 

until the control stick resets itself independently.

The right control stick gimbal is specular to the left one, so that here 

the screw is located left under the middle.

Brake spring and ratchet

The outboard screw of the two marked in the figure adjust the brak-

ing force.
The inboard screw adjusts the strength of the ratchet for the respec-

tive control stick.

The right control stick gimbal is specular to the left one, so that here 

the screws are located right on the top side.

Control sticks centering force

The control sticks' restoring force can also be adjusted. The adjust-

ment is located next to the return springs.
By turning the respective adjust screw the spring force can be 

adjusted.
Right turn = return harder
Left turn = return softer

The right control stick gimbal is specular to the left one, so that here 

the screws are located left in the middle.