MG International 040 ユーザーズマニュアル
Installation and operation guide - 12
WARNING: The installation of the joints and foam pads, like the fastening, must be done with care to
ensure waterproofing and proper running of your device.
-
Check that the two large black joints are properly positioned in their housing on the base.
-
Put the rigid angled tube back in place (Pict. 16)
-
Put the cover back in place and screw the 4 screws as tightly as possible (do not use an electric screwdriver)
and put the 4 protective caps in place (Pict. 17 & 18)
and put the 4 protective caps in place (Pict. 17 & 18)
-
Fasten the rigid angled tube on the device by screwing the small screw in the hole on top of the rigid tube
-
.
Pict. 13
Pict. 13
Pict. 14
Pict. 15
Pict. 16
Pict. 17