MG International 040 ユーザーズマニュアル
Installation and operation guide - 10
5.4 Tests
-
Make sure that the pool is still. If you have a swim jet, turn it off.
-
Prepare a 2.5 US gallon jerry can with enough water to reach a weight of 18 lbs (8 kg), and tie the 6
foot rope to it to recover it when performing fall tests.
foot rope to it to recover it when performing fall tests.
NOTE: If you wish, you can conduct your tests in low-volume siren mode (optional). In this mode, the
volume of the siren is reduced and the siren stops automatically after 5 seconds. Refer to §
volume of the siren is reduced and the siren stops automatically after 5 seconds. Refer to §
7.5
for further
details.
-
-
For these tests, Swim Alert™ must be in ARMED mode (green indicator light flashing). If such is not
the case, move the magnet over the swimmer symbol.
the case, move the magnet over the swimmer symbol.
-
If in spite of this, the indicator light does not switch to green, this means that the pool is not still
enough. You must imperatively wait until your pool is still before carrying out the tests.
enough. You must imperatively wait until your pool is still before carrying out the tests.
•
Test 1 - Robot cleaner + filtering
-
Leave Swim Alert™ in ARMED mode for 10 minutes with the filtering on and the robot cleaner working,
only if you have a robot cleaner.
only if you have a robot cleaner.
o
Swim Alert™ must remain in ARMED mode (green indicator light flashing) without the siren
going off.
going off.
Some diving type robot cleaners (a robot which moves out of and dives back into the water, possibly causing a
disturbance similar to a fall) are not compatible with fall detectors.
If this test fails:
-
Look up item 8, page X.
-
Contact your retailer
-
Contact our technical support service: usa@swim-alert.com
•
Test 2 - Falls
-
Make sure that your device is in ARMED mode
(green indicator light flashing)
(green indicator light flashing)
1) Move to the spot furthest away from your fall
indicator (Pict. 9)
-
Simulate the fall of a person by dropping the 18
lbs jerry can from the top of the coping.
lbs jerry can from the top of the coping.
o
The siren must go off less than 20 seconds
after the fall.
after the fall.
o
Turn the alarm off by moving the magnet over
the swimmer symbol.
the swimmer symbol.
Wait for your fall detector to restart automatically (1
long beep – green indicator light flashing).
During the tests, after each fall, you must wait for the automatic reactivation of Swim Alert™ before
performing another fall. Depending on wind and pool disturbance conditions, this reactivation may take
about ten minutes.
2) Move to 3 feet away from your fall detector
-
long beep – green indicator light flashing).
During the tests, after each fall, you must wait for the automatic reactivation of Swim Alert™ before
performing another fall. Depending on wind and pool disturbance conditions, this reactivation may take
about ten minutes.
2) Move to 3 feet away from your fall detector
-
Simulate the fall of a person by dropping the 18 lbs jerry can from the top of the coping.
o
The siren must go off less than 20 seconds after the fall.
o
Turn the alarm off by moving the magnet over the swimmer symbol.
The test is validated.
If one of these tests fails:
-
Look up § 8.
-
Contact your retailer
-
Contact our technical support service: usa@swim-alert.com
All the tests have been conducted successfully, you may now proceed with the final installation of your device.
Pict. 9