MG International 040 ユーザーズマニュアル
Installation and operation guide - 16
7 Using Swim Alert™
The magnets must be kept out of the reach of children.
PRECAUTIONS FOR USE
•
Swim Alert™ is not intended as a substitute for the watchfulness of parents and/or responsible adults,
which remains the essential factor for the protection of children under the age of five.
which remains the essential factor for the protection of children under the age of five.
•
Action must be taken when the siren is heard.
•
Certain rough weather conditions (strong winds, storms, etc.) and the use of certain powerful cleaning
equipment can cause untimely alarm triggering.
equipment can cause untimely alarm triggering.
•
Your alarm system will not operate if the water in the probe is frozen or the surface of the pool is
frozen. It is hard to know when the water is frozen in the tube. If in doubt, check that your fall
detector is working properly.
frozen. It is hard to know when the water is frozen in the tube. If in doubt, check that your fall
detector is working properly.
•
When cleaning the outside of your device, (waterline,…), do not use any high-pressure cleaning
apparatus, abrasive brush and/or other implements which might scratch or damage your fall detector.
apparatus, abrasive brush and/or other implements which might scratch or damage your fall detector.
•
Proper operation of Swim Alert
TM
cannot be guaranteed in the presence of a bubble pool cover.
•
To ensure proper operation of your device, please keep the water pure and clean (in particular, to
avoid the formation of algae inside the probe).
avoid the formation of algae inside the probe).
•
Should you restart your detector after a long period, perform the tests described in § 5.4. In case of a
problem, contact your retailer immediately.
problem, contact your retailer immediately.
•
The only authorized operation on the device once it is installed is changing the battery.
•
Regularly check that your fall detector is working properly by performing the monthly tests mentioned
in this guide (see § 11).
in this guide (see § 11).
•
Some robot cleaners of the diving robot type are incompatible with fall detection systems.
•
Any user who shuts off the system must be aware that surveillance by a person must take over from
the system.
the system.
•
The greatest vigilance by the parent/responsible adult is necessary between the end of the swim and
reactivation of the alarm system.
reactivation of the alarm system.
7.1 I want to have a swim
-
Your fall detector is in monitoring mode (green indicator light flashing)
-
Move the magnet over the swimmer symbol, you will hear 5 short beeps, the red indicator light flashes.
-
You can have a swim.
After swimming, the pool will not be monitored until the device is restarted, which will happen when the pool is
still again. The device is restarted about ten minutes after the swim.
D
URING THIS TIME
,
YOUR POOL IS NOT PROTECTED
.
U
TMOST VIGILANCE IS REQUIRED FROM THE PARENT
/
RESPONSIBLE ADULT
.