MG International 040 ユーザーズマニュアル
Installation and operation guide - 18
7.5 Low-volume siren mode
In this (optional) mode, your siren sounds only for a short time and at a low volume, to allow you to perform the
installation tests and the monthly tests without disturbing you or the neighborhood.
-
The TESTS mode lasts for 30 minutes.
-
The start and stop of the TEST mode are indicated by a specific tune.
To manually start and stop the tests mode, place and keep the magnet
on the swimmer symbol until the sound validation (loud beep) and
until the red indicator light flashes quickly. Perform this operation 3
times in a row (Pict. 25).
*
-
Manual start of the TESTS mode: red indicator light continuously
on during the specific tune.
on during the specific tune.
-
Manual end of the TESTS mode: green indicator light
continuously on during the specific tune.
continuously on during the specific tune.
*Warning: When you place the magnet on the swimmer symbol, the device responds at first as described in
§7.1 “I want to have a swim” and in §7.3 “Manual restart”. You must keep the magnet on this area to have sound
validation (indicated by a loud beep) and fast flashing of the red indicator light.
7.6 Complete stop
In complete stop mode, all Swim Alert™ indicator lights are off.
When Swim Alert™ is in complete stop mode, vigilance by a person must imperatively
take over, or another safety system must be installed as an alternative.
To turn off your device, place and keep one of the magnets on
the swimmer symbol until the sound validation (loud beep) is
heard, and until the red indicator light flashes quickly, then
move the 2
the swimmer symbol until the sound validation (loud beep) is
heard, and until the red indicator light flashes quickly, then
move the 2
nd
magnet over the red Stop symbol (Pict. 26). The red
indicator light remains on during the confirmation sound signal
(15 short beeps).
*Warning: When you place the magnet on the swimmer symbol,
the device responds at first as described in §7.1 “I want to have
a swim” and in §7.3 “Manual restart”. You must keep the magnet
on this area to have sound validation (indicated by a loud beep)
and fast flashing of the red indicator light.
(15 short beeps).
*Warning: When you place the magnet on the swimmer symbol,
the device responds at first as described in §7.1 “I want to have
a swim” and in §7.3 “Manual restart”. You must keep the magnet
on this area to have sound validation (indicated by a loud beep)
and fast flashing of the red indicator light.
To reactivate Swim Alert™:
o
Move the magnet over the swimmer symbol;
o
You will hear 5 short, high-pitched beeps + flashing red indicator light.
o
Wait for the automatic restart (flashing green indicator light) or restart manually (see §7.3).
Please make sure that Swim Alert™ is in monitoring mode before leaving your pool.
If such is not the case, utmost vigilance is required from the parent/responsible adult.
Pict. 25
Pict. 26