MG International 040 ユーザーズマニュアル

Installation and operation guide - 6

Failure signals

Sound signals

Failure

With the magnet

Periodic

Batteries low

4 short, low-pitched

beeps

1 short, low-pitched beep every minute

Malfunction

Return to the after-sales

service

–

2 short, low-pitched beeps every

minute

5 Installing Swim Alert™

INSTALLATION PRECAUTIONS

•

Check that the Swim Alert

sirens can be heard from inside your home.

•

Your fall detector must be installed in good weather on a still pool.

•

The alarm system must be installed at a location where the water depth is 12 in. minimum.

•

The probe (rigid angled tube + black flexible tube) might have to be cut to obtain an immersion depth
of 8.5 in. (+/- 1 in.). The installation of a level controller is recommended. Contact your retailer for
advice.

•

Make sure that the water in your pool is clear and pure before installing your device.

•

Some robot cleaners of the diving robot type are incompatible with fall detection systems.

•

Proper operation of Swim Alert

cannot be guaranteed in the presence of a bubble pool cover.

•

Warning: Swim Alert™ is fitted with a powerful siren (over 100 dB). In case the siren should go off,
please take all necessary precautions to protect your auditory system during the installation.

Tools required for installation:

1 Phillips screwdriver

1 tape measure

1 2.5 US gallon jerry can

1 rope about 6 ft long.

1 drill with concrete bit Ø 0.31 in (8mm)

1 hacksaw

1 pencil

Your fall detector is installed in 6 steps:

5.1 Insertion of the batteries
5.2 Choice of location
5.3 Temporary installation
5.4 Installation tests
5.5 Final installation
5.6 Validation tests

TMOST VIGILANCE IS REQUIRED FROM THE PARENT

RESPONSIBLE ADULT DURING THE INSTALLATION OF

YOUR FALL DETECTOR