EDATA COMMUNICATIONS INC. DSL-2140W ユーザーズマニュアル
Proprietary & Confidential
Page 76 of 80
Revision: V1.0
Jan. 19 2008
STEPS CORRECTIVE
ACTION
1
Check the telephone wire and connections between the DSL-2140/2140W DSL port and
the wall jack.
2
Make sure that the telephone company has checked your phone line and set it up for
DSL service.
3
Reset your ADSL line to reinitialize your link to the DSLAM.
4
If the problem persists, contact your local distributor for assistance.
A.2 Problem: Can’t Access Through Telnet
I cannot telnet into the DSL-2140/2140W.
STEPS CORRECTIVE
ACTION
1
Check the LAN port and the other Ethernet connections.
2
Make sure you are using the correct IP address of the DSL-2140/2140W. Check the IP
address of the DSL-2140/2140W.
3
Ping the DSL-2140/2140W from your computer.
If you cannot ping the DSL-2140/2140W, check the IP addresses of the
DSL-2140/2140W and your computer. Make sure your computer is set to get a dynamic
IP address; or if you want to use a static IP address on your computer, make sure that it
is on the same subnet as the DSL-2140/2140W.
4
Make sure you entered the correct password. The default password is “1234”.
If you forgot your username or password, refer to Section A.4.
5
If the problem persists, contact the distributor.
A.3 Problem: Can’t Access Web Configurator
I cannot access the Web configurator.
STEPS CORRECTIVE
ACTION
1
Make sure you are using the correct IP address of the DSL-2140/2140W. Check the IP
address of the DSL-2140/2140W.
2
Make sure that a console session isn’t running.
3
Check that you have enabled Web service access. If you have configured a secured
client IP address, your computer’s IP address must match it. Refer to the chapter on
remote management for details.
4
For WAN access, you must configure remote management to allow server access from
the WAN (or all).