Guangzhou Chiyuan Electronic Co. Ltd. X-3 ユーザーズマニュアル
SERVO
0
20%
100%
120%
20%
100%
120%
RIGHT
FWD
LEFT
BACK
BACK
X y 3 0 0
2 . W i t h t h e s y s t e m h o o k e d
u p
u p
a s
s h o w n ,
i n s e r t
t h e
b i n d
p l u g
i n
t h e
c h a r g e
p l u g
r e c e p t a c l e . T u r n
o n
t h e p o w e r o f t h e r e c e i v e r
( 4 . 8 ~ 5 . 6 v ) ,
( 4 . 8 ~ 5 . 6 v ) ,
a n d
n o w
L E D ( x y 3 0 0 )
s h o u l d
b e
f l a s h i n g i n d i c a t i n g
t h a t
t h e r e c e i v e r i s r e a d y t o
AUX Channel Function(CH3)
SER
VO
0
100%
100%
When pressing the “AUX”channel ,the servo moving clockwise,
pressing again, anticlockwise
BIND
ST.D/R
F/S
Funtion
Using this function to to adjust servo travel.
The default is 100%.When pressing D/R ,the front light flash,
and the value quickly switch to 70%.
and the value quickly switch to 70%.
Function
This F/S Funtion is protect your car or boat,when the signal become weak
or lost.
How to set
1.Make sure the RX power is enough.
2.Put trigger in brake position(above show). Keep the F/S button till
“ST.DR” become red.
3. Then release F/S button, the function finished.
This F/S Funtion is protect your car or boat,when the signal become weak
or lost.
How to set
1.Make sure the RX power is enough.
2.Put trigger in brake position(above show). Keep the F/S button till
“ST.DR” become red.
3. Then release F/S button, the function finished.
Lock Function
When press “RF-TEST” button and “F/S” button together, the front
light become red, means locked.(Making sure you touch the ST.TRIM ,
TH.TRIM and D/R no response). Both press again, means unlocked.
When press “RF-TEST” button and “F/S” button together, the front
light become red, means locked.(Making sure you touch the ST.TRIM ,
TH.TRIM and D/R no response). Both press again, means unlocked.
1).Keep pressing RF-TEST button till the “ST.DR” light turn on RED.
Meanwhile the output power of transmitter reduce to lower mode 18dbm,
which done can save the power consumption.
which done can save the power consumption.
2).When press the RF-TEST button again, the “ST.DR” light turn off, and
output power becomes normal 20dbm which can control more range.
output power becomes normal 20dbm which can control more range.
RESET
Function
All the setting in the system will be
reset to the default values by
All the setting in the system will be
reset to the default values by
this reset function.
1.Press the ST.D/R and put the TH.TRIM
forward together, then turn on
the TX at the same time, the light of POWER
and ST.DR are flashing, means it is resetting.
2.Making sure this function work, you have to
turn off TX and turn on it again.
LOCK
Steering Dual Rates Choice
ST.D/R
TH.D/R