SmartSight Networks Inc MF24 ユーザーズマニュアル
39
_____________________________________________________________________________________________
Microflex AV/ADV/AVr/ADVr North-American user’s manual / Rev 1.4
5.3 Connecting the KBD4000
TM
to the Microflex video receiver
KBD4000
TM
- RJ45 Pin-out (DTE)
Microflex Receiver (DCE)
Interconnect Board (JP16 or JP17)
1
Pin 1 : TX+
Pin 1: TX+
Pin 2 : TX-
Pin 2: TX-
Pin 3 : 12 VAC/DC NON POLAR
2
Pin 4 : 12 VAC/DC NON POLAR
2
Pin 5 : GND
Pin 5: GND
Pin 6 : No Connect
Pin 7: RX-
Pin 4: RX-
Pin 8: RX+
Pin 3: RX+
1
For MF24-AVr/ADVr, DATA1 is referred to as JP16 on the interconnect board. For
FV module, DATA1 is referred to as JP17. Note that on both interconnect board
models, Pins 1-5 are counted from left to right.
models, Pins 1-5 are counted from left to right.
2
A 12VAC power supply on Pins 3 and 4 or a 12VDC on Pin 3 and pin 5 (ground) must be
supplied.
5.4 Connecting the KBD4000
TM
to multiple Microflex receivers
It is possible to use a single KBD4000
TM
to control two (2) or more video
receivers (any of three models). To support this, proceed as follows: