SmartSight Networks Inc MF24 ユーザーズマニュアル
37
_____________________________________________________________________________________________
Microflex AV/ADV/AVr/ADVr North-American user’s manual / Rev 1.4
CHAPTER 5 Using the KBD4000 in a Multisite Network
This Chapter describes the installation of a Pelco KBD4000
TM
keyboard controller (or
equivalent) in a Comlink Multisite
TM
video network. In a multi-point network, the keyboard
must be used
to select cameras, views, and other options.
The Pelco KBD4000 can also be used in a point-to-point network to support Quad View
display and future advanced options. Note however that in point-to-point, if a single
camera is used, the data port can be made transparent to support any Pan-Tilt-Zoom
protocol.
There are important facts the users should know about the utilisation of a KBD4000
TM
in a
Multisite Network:
• The KBD4000
TM
must be connected to a receiver unit (MF24-AVr/ADVr or FV).
• The KBD4000
TM
must be configured in <multiplexer mode> for proper operation.
• The video receiver (MF24-AVr/ADVr or FV) DATA1 serial port must be set to
“Genex Mode” to support the KBD4000 keyboard (see Chapter 4)
In ‘Genex Mode’, the MF24-Avr/ADVr (or FV) emulates a Pelco Genex
TM
multiplexer. The
receiver is therefore interchangeably referred to as a video receiver or multiplexer
throughout this Chapter.
throughout this Chapter.
2
ComLink has plans to release a Windows based software which emulates the KBD4000
TM
. Please
contact our Technical support team to have an update on the release date
.