SmartSight Networks Inc MF24 ユーザーズマニュアル
45
_____________________________________________________________________________________________
Microflex AV/ADV/AVr/ADVr North-American user’s manual / Rev 1.4
The pan, tilt and zoom functionality is easy to use in a Multisite network. From the
Full or Quad View mode, you must type the camera ID number followed by the
<CAM> key. Then, just move the joystick up and down for pan control, left and right
for tilt control, and twist it for zoom control.
Full or Quad View mode, you must type the camera ID number followed by the
<CAM> key. Then, just move the joystick up and down for pan control, left and right
for tilt control, and twist it for zoom control.
5.7 Password
You can program the multiplexer to request a password for access to programming
menus. The password is enabled in the Advanced System Setup menu (refer to the
Advanced System Setup section).
The universal password is 3916 and cannot be changed. This password must be
entered whenever one is requested. The password is entered from the keyboard by
pressing each number followed by the CAM key: <3>, <CAM>,<9>, <CAM>, <1>,
<CAM>, <6>, <CAM>.
5.8 Using one KBD4000
TM
and multiple video receivers.
To select the receiver you want to configure: enter the receiver ID (a number
between 1 and 16) and then press the UNIT key. Ex: <6>, <UNIT>.
Once a receiver is selected, all the commands will be send to it until another
receiver is selected.
To select all the receivers: enter <0> and then press the <UNIT> key.
____________________________________________________________________________
The module ID of the Microflex video receiver (MF24-AV/Avr or FV) must be set between 1
and 16 to work properly. After a power-down sequence or software reboot all the
receivers will respond to the keyboard commands.
____________________________________________________________________________
The module ID of the Microflex video receiver (MF24-AV/Avr or FV) must be set between 1
and 16 to work properly. After a power-down sequence or software reboot all the
receivers will respond to the keyboard commands.
____________________________________________________________________________