IKUSI ELECTRONICA S.L. RAD-RF ユーザーズマニュアル
SAFETY PRECAUTIONS
These instructions must be read carefully in order to install and use the radio
control system properly and to keep it in perfect working condition and to reduce
the risks of misuse.
Do not use this system on machines for the lifting of persons or in potentially
explosive atmospheres.
Any use other than that specified in this manual is dangerous. The following
instructions must be strictly adhered to.
Important note: To comply with FCC RF exposure compliance requirements, this
device and its antenna must not be operating in conjunction with any other
antenna or transmitter.
WARNING:
Modifications to this equipment are expressly forbidden by the FCC Rules.
Changes or modifications not expressly approved by the party responsible for
compliance may void the user's authority to operate this equipment.
Modifications to this equipment are expressly forbidden by the FCC Rules.
Changes or modifications not expressly approved by the party responsible for
compliance may void the user's authority to operate this equipment.
1.1 What you must do
Strictly adhere to the instructions for installation contained in this manual
.
Make sure that professional and competent personnel carry out the installation.
Ensure that all site and prevailing safety regulations are followed.
Make sure that this manual is permanently available to the operator and maintenance
Ensure that all site and prevailing safety regulations are followed.
Make sure that this manual is permanently available to the operator and maintenance
personnel.
Keep the transmitter out of reach of unauthorised personnel.
Remove the transmission key when the system is not in use.
At the beginning of each work shift, check to make sure that the STOP button and
Remove the transmission key when the system is not in use.
At the beginning of each work shift, check to make sure that the STOP button and
other safety measures are working.
When in doubt, press the STOP button.
Whenever several systems have been installed, make sure the transmitter you are going
Whenever several systems have been installed, make sure the transmitter you are going
to use is the correct one. Identify the machine controlled on the label for this purpose
on the transmitter.
on the transmitter.
Service the equipment periodically.
When carrying out repairs, only use spare parts supplied by the manufacturer dealers.
When carrying out repairs, only use spare parts supplied by the manufacturer dealers.
Use only battery pack BT06K 4.8V 700mAh.
1.2 What you must not do
Never make any changes to the radio control system, which have not been engineered
and approved by the manufacturer.
Never power the equipment other than with the specified power supply.
Never allow unqualified personnel to operate the equipment.
Never allow unqualified personnel to operate the equipment.
RADS11 and RADF13 Users Manual ver1.2.doc
KCI Hoists Corp. reserves the right to modify this information without prior notification.
KCI Hoists Corp. reserves the right to modify this information without prior notification.
Page 5 of 20