IKUSI ELECTRONICA S.L. RAD-RF ユーザーズマニュアル

 

 
 
 

 
Make sure that the crane is stopped for the entire duration of the installation 
process, keep the work area free and wear protective clothing. 
Park the crane and position  at end stop, (if these are not available use appropriate 
signs), at a suitable distance so that other cranes do not hit it on the same runway. 
Check the power-supply voltage and turn off the main switch. 
 
Find a suitable location for the receiver, away from any intense radioelectric disturbance 
sources and install the receiver using the 4 elastic rubber absorbers, (M8) supplied with 
the set. 
 

6,7’’(inch)

  

10’’ (inch)  

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 
The receiver must be placed free of shielding. Metal parts that could obstruct reception 
of the radio signal must be avoided.

 

 
The way to connect the receiver box to the crane's electrical installations is using a cable 
with a terminal multiple-pole connector: 
 
 
 
Note:  See attached drilling pattern sheet.  
 

RADS11 and RADF13 Users Manual ver1.2.doc 
KCI Hoists Corp.  reserves the right to modify this information without prior notification. 

Page 7 of 20