IKUSI ELECTRONICA S.L. RAD-TF ユーザーズマニュアル
While the system is in service mode the “envelope” icon in the
display will be switched ON. (Figure 8).
display will be switched ON. (Figure 8).
Figure 8
LCD Display in Service Mode
6.3 Keys for moving within the Menus.
The keys for moving within the menu are the following (Figure 9):
♦ UP: Button that simulate the Up Key. Up button. ▲
♦ DOWN: Button that simulate the Down Key. Down
♦ DOWN: Button that simulate the Down Key. Down
button. ▼
♦ ESC: Button that simulate the Esc Key. Left button.
◄
♦ ENTER: Button that simulate the Enter Key. Right
button. ►
Figure 9
Pushbutton as a Key board for Crane Condition Monitoring Unit
6.4 Switching from Tared Load to Actual Load.
The actual load is shown in the display unit as the Tared Load, but an “A” is shown
below the “t” in the bottom right hand side of the display unit. In order to switch from
Tared Load to actual load, this is performed by pressing up and/or down. Pressing
ENTER, the password is requested.
below the “t” in the bottom right hand side of the display unit. In order to switch from
Tared Load to actual load, this is performed by pressing up and/or down. Pressing
ENTER, the password is requested.
Figure 10
LCD representing Tared Load
6.5 Resetting the Tared Load.
The reset of the Tared Load is performed by pressing the
ESC button for several seconds.
ESC button for several seconds.
RADS11 and RADF13 Users Manual ver0.4a.doc
KCI Hoists Corp. reserves the right to modify this information without prior notification.
KCI Hoists Corp. reserves the right to modify this information without prior notification.
Page 16 of 23