IKUSI ELECTRONICA S.L. RAD-TF ユーザーズマニュアル

 

 

 Never allow unqualified personnel to operate the equipment. 
 After use, never leave the equipment ON. Always use the contact key or the STOP 

button to avoid accidentally activating manoeuvres. 

 Do not use the set when visibility is limited. 
 Avoid knocking or dropping the set. 
 Do not use the set if failure is detected. 

 

 

 
Connect the charger to the mains using the power source and the cable supplied. The red 
LED, in the middle, should light up indicating power ON. 
 
When installing the battery charger, bear in mind that the batteries must be charged at 
temperatures over 5ºC (41F) and that the power supply must be left on all night. Also 
remember that the charger must not be left in direct sunlight, as the batteries may not 
become fully charged at temperatures 
exceeding 35ºC (95F). 
 
Place the batteries in the charger. 
There is green LED on top of each 
battery. Each LED should light up, 
indicating that recharging is in 
process. Complete recharging takes 
approximately 12 hours. After 
charging process is finished, the 
green LED is turned OFF.  The 
batteries may remain in the charger 
for an unlimited period of time. 
 

 
The capacity of the batteries decreases with use. Their life span is estimated to be 500 
recharging cycles, but this depends largely on the conditions of use, for which the 
following is recommended: 
 

 Do not recharge the battery until it is completely empty. The transmitter indicates this. 
 Always charge the batteries at temperatures between 5º(41F) and 35ºC (95F). 
 Avoid short-circuits between the battery contacts. Do not carry charged batteries in 

toolboxes or next to other metal objects (keys, coins, etc.). 

 Always keep contacts clean. 
 Never leave batteries in direct sunlight. 

 

RADS11 and RADF13 Users Manual ver0.4a.doc 
KCI Hoists Corp.  reserves the right to modify this information without prior notification. 

Page 6 of 23