Wilson Electronics LLC 272770 ユーザーズマニュアル

 Warning: 

 

Lightning protection is recommended for all installations  

 

 

(sold separately part #859902) . Take extreme care to  

 

 

ensure that neither you nor the antenna comes near any  

 

 

electric power lines .

Select a location on the roof of the building to install the Outside Antenna . Use 

a cell phone in test mode to find the strongest signal from the cell tower (see 

below for more information) . To get the strongest signal possible, it is very 

important to set up your Outside Antenna properly . The Inside and the Outside 

Antenna must be mounted in such a way that they are able to pick up the best 

possible cell signal on the outside of the building and provide the best possible 

signal on the inside of the building . Mount the Outside Antenna as high as 

possible facing the cell tower in an area with the best possible signal coverage . 
Note: Never point the front of a Directional Antenna toward the Inside  

 

(sold separately)

Install the 

Protector (LSP) close to the Signal 

Booster .  Attach the cable from 

the Outside Antenna to the surge 

protector, using a short length of low 

loss cable; attach one end to the 

LSP and the other to the Outside 

Antenna connector on the Signal 

Booster . Ensure the LSP is properly 

grounded (ground wire not included) . 

Visit www.WilsonElectronics.com

or contact Wilson Electronics Sales 

Team at 800-204-4104 .

When installing your Signal Booster’s Outside Antenna, aiming it towards 

the best signal source from you service provider is important .  The best way 

of getting the strongest signal is to have one person on the roof to rotate 

the Outside Antenna, which is connected to the Signal Booster . Turning the 

Outside Antenna about 45 degrees at a time, while the second person is 

watching the signal strength on the phone inside the building . This allows 

you to read the signal strength from the cell tower .  It is preferable to have 

Signal Booster

Ground Wire