Wilson Electronics LLC 277180 ユーザーズマニュアル
1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Select a location to install the Signal Booster that is away from
1 .
excessive heat, direct sunlight, moisture and has proper ventilation . Do
not place the Signal Booster in an air-tight enclosure .
Select a location on the roof of the building to install the Outside Antenna .
Select a location on the roof of the building to install the Outside Antenna .
2 .
Use a cell phone in test mode to find the strongest signal from the cell tower .
See page 5 . Visit www.WilsonElectronics.com to find the test mode function
for your particular cell phone .
Run the Outside Antenna cable to the Signal Booster and attach it to the
Run the Outside Antenna cable to the Signal Booster and attach it to the
3 .
connector labeled “Outside Antenna” on the Signal Booster . Run the Inside
Antenna cable to the Signal Booster and attach it to the connector labeled
“Inside Antenna” on the Signal Booster . See page 8 for more information on
running cable . Lightning Surge Protection is recommended for all in-building
installations see page 7 .
Select a location for the Inside Antenna, preferably in the center of
Select a location for the Inside Antenna, preferably in the center of
4 .
where the signal needs to be amplified . A minimum separation distance
of 20
vertical (within the null zone) or 50 horizontal feet is necessary
for proper operation . If the inside coverage is not sufficient you may
need to increase the separation distance even further (see installation
diagram on pages 3 & 4) .
Before powering up the Signal Booster, verify that both the Outside
Before powering up the Signal Booster, verify that both the Outside
5 .
Antenna and the Inside Antenna are connected and check that all
connections are tight . See page 9 .
Note: Be careful when plugging the
connectors in so as not to bend the center pins on the connectors.
Press yellow “CH Select” button to desired setting . Your channel will
Press yellow “CH Select” button to desired setting . Your channel will
6 .
show on the LCD screen . See page 11-12 .
The Signal Booster has been packaged with the gain control knobs
The Signal Booster has been packaged with the gain control knobs
7 .
adjusted to the highest gain position . If light is not green, please refer to
pages 12-14 .
Quick Install Overview
See Installation Diagram on page 3 . Contact Wilson Electronics Technical
Support Team with any questions at 866-294-1660 .
Warning:
Connecting the Signal Booster directly to a cell phone with
use of an adapter will damage the cell phone and/or the
Signal Booster .
Wilson
®
Electronics recommends that all AC power
supplies for home electronics be plugged into a
Surge Protector Power Strip.