Wilson Electronics LLC 277180 ユーザーズマニュアル

Anyone who uses a cell phone or cellular data card knows the frustration 

of not being able to connect to or maintain a strong cellular signal . When 

this occurs, it is generally due to one of two reasons:

Location  of  the  Nearest  Cell  Tower  –  Cell  towers  are  situated  to 

1 . 

provide  broad  coverage;  however,  there  are  many  areas  in  which 

signal strength may be reduced by topographic features or by local 

government  restrictions  on  the  height  or  placement  of  the  towers 

themselves . Rural areas generally have fewer cell towers than urban 

regions .

Natural  and  Man-Made  Obstructions  –  Signal  strength  can  also 

2 . 

be  negatively  affected  by  trees,  hills,  buildings,  weather,  and  other 

obstructions . You may be relatively close to a cell tower but still unable 

to make a call . This often occurs in homes, offices and other buildings 

in which stucco, concrete or metal walls may block the signal .

The  Signal  Booster  works  with  two  antennas .  The  Inside  Antenna 

communicates with your cell phone and the Outside Antenna communicates 

with the cell tower . The Outside Antenna receives the cell tower signal and 

sends it through the cable to the Signal Booster, where it is amplified and 

transmitted through the Inside Antenna into the room . When the Inside 

Antenna picks up a signal from your cellular device, the Signal Booster 

amplifies that signal and transmits it through the cable, then through the 

Outside Antenna and back to the cell tower . (

When installing your Signal Booster’s Outside Antenna, aiming it towards 

the best signal source from you service provider is important .  The best 

way of getting the strongest signal is to have one person on the roof to 

rotate the Outside Antenna, which is connected to the Signal Booster . 

Turning the Outside Antenna about 45 degrees at a time, while the 

second person is watching the signal strength on the phone inside the 

building . This allows you to read the signal strength from the cell tower .  

It is preferable

 

to have the phone in the test mode so the actual

 

signal 

strength can be read, as bars are not the most accurate . Go to

www.WilsonElectronics.com for help in finding the test mode for your 

phone . Always make sure the person inside the building gives the signal 

time to arrive and register on the phone (between 10-30 seconds for 

phone to reset to the signal reading) .