Wilson Electronics LLC 2B2725 ユーザーズマニュアル

2.  Attach the Mounting Bracket
A mounting bracket is provided for attaching the Sleek to your vehicle’s dash. Other options are also 

available from Wilson Electronics.  

Sleek power port. Connect Wilson 

Electronics power supply.

Antenna 

connection

Accessory USB power port 

3.  Attach the Sleek to the Bracket
Once you have installed the bracket in the desired location, and waited 24 hours for adhesive to cure, attach 

the Sleek by aligning the rectangular hole on its back with the tab on the mount bracket, grasping the sides of 

the Sleek, and sliding it downward approximately ¼ inch (0.6 cm) into place. 

RF Safety Warning: The “Outside Antenna” must be either a Wilson Electronics Magnet Mount 

or Mini-Magnet Mount Antenna and requires at least an 8 inch (20 cm) separation distance from 

all persons.  Other Outside Antennas may be used with fixed building installations provided that (a) they 

are located with at least a 8 inch (20 cm) separation distance from all persons, (b) their gain less cable 

loss does not exceed 3.4 dBi, and (c) they are not operating in conjunction with any other antenna or 

Signal Booster.

 ADHeSIVe BRACKeT- Included in this package
A. Clean the area where the bracket is to be mounted with the  

  alcohol wipe provided. Allow to dry.

B. Peel the backing to expose the adhesive and press the bracket 

onto the desired location in the vehicle. 

C. 

Sleek.

D. Once the cradle is attached, you can adjust the angle of the 

adhesive bracket by applying gentle pressure to the top or 

bottom of the Sleek. The bracket is designed to swivel when 

the knurled nut is loosened for greater adjustability of the Sleek 

viewing angle. To lock bracket into position, tighten large nut.

Power up the Wilson electronics Sleek 
IMPORTANT:  Make sure the Outside Antenna cable is connected 

before powering up the Sleek.
Accessory port to power up your phone, some adapters available 

through Wilson Electronics at 866-294-1660 (refer to Figure 1).

Connect the mini-USB plug on the power cable to the Sleek’s mini 

USB port located on the bottom of the Sleek (refer to Figure 2) and 

insert the adapter into the vehicle power outlet of your vehicle. The 

Sleek may remain on all the time.  However,  leaving the Sleek on 

in a vehicle when it is not running can discharge the battery in a day 

or two.

Warning:  Use only the supplied Wilson Electronics power  

 

supply.

4.  Attach the Outside Antenna cable to the Sleek
Attach the cable from the Outside Antenna to the antenna connector on the Sleek. (see Figure 2)

Figure 1

Figure 2