Netgear 10300138 ユーザーズマニュアル

No lights are lit on the product family.

It takes a few seconds for the Power LED to light. Wait a minute and check the Power LED on 
the access point. If the access point has no power:

Make sure that the power cord is connected to the access point.

Make sure that the power adapter is connected to a functioning power outlet. If it is in a 

power strip, make sure that the power strip is turned on. If it is plugged directly into the 
wall, verify that it is not a switched outlet.

Make sure that you are using the correct NETGEAR power adapter supplied with your 

access point.

No lights are lit on the access point.

It takes a few seconds for the power indicator to light up. Wait a minute and check the power 
light status on the access point. If the access point has no power.

Make sure the power cord is connected to the access point.

Make sure the power adapter is connected to a functioning power outlet. If it is in a power 
strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify 
that it is not a switched outlet.

Make sure you are using the correct NETGEAR power adapter supplied with your access 

point.

The Wireless LAN LED does not light up.

The access point antennas are not working.

If the Wireless LAN LED stays off, disconnect the adapter from its power source, and then 

plug it in again. 

Make sure that the antennas are securely connected to the WNAP320. 

Contact NETGEAR Technical Support if the Wireless LAN LED remains off.

The Wireless LAN activity light does not light up.

The access point’s antenna is not working.

If the Wireless LAN activity light stays off, disconnect the adapter from its power source 

and then plug it in again. 

Make sure the antennas are tightly connected to the access point. 

Contact NETGEAR technical support if the Wireless LAN activity light remains off.