AeroScout BS2035-0 ユーザーズマニュアル
Exciter Hardware | 7
must have a wired connection for configuring the Exciter. In addition, some
of the monitoring functions will not be available if the Exciter is not wired.
of the monitoring functions will not be available if the Exciter is not wired.
The LAN connector is not sealed if the Ethernet RJ-45 cable is just plugged
into the connector. In order to seal it, use the sealing adapter shown in Figure 4,
which is supplied with the Exciter. The CAT5 cable must be threaded through
the adapter prior to clamping the RJ-45 connector. After connecting the RJ-45
to the connector on the Exciter, the adapter should be fastened to the LAN
connector base (1).
into the connector. In order to seal it, use the sealing adapter shown in Figure 4,
which is supplied with the Exciter. The CAT5 cable must be threaded through
the adapter prior to clamping the RJ-45 connector. After connecting the RJ-45
to the connector on the Exciter, the adapter should be fastened to the LAN
connector base (1).
Figure 4. Ethernet LAN connection sealing adapter
The protective cap supplied with the Exciter (see Figure 5) is also fastened to the
cover base (1). When working in standalone mode (without a permanent wired
LAN connection), this cap should be used to seal the LAN connection.
cover base (1). When working in standalone mode (without a permanent wired
LAN connection), this cap should be used to seal the LAN connection.
Figure 5. Ethernet LAN connection protective cap
2. Power jack – 110/220VAC. The power adapter plug (see Figure 6)
supplied with the Exciter, should be assembled to a power cord and
connected to the power jack.
supplied with the Exciter, should be assembled to a power cord and
connected to the power jack.
Figure 6. Power adapter plug