Boston Scientific Neuromodulation Corporation PSC5210W ユーザーズマニュアル

38

Physician Implant Manual

Some Remote Control functions (i.e., patient Options and Clinician 
Mode) are accessed via a “long button press” (press and hold for 
approximately three seconds). These are identified in the appropriate 
sections following.

Stimulation On/Off
Stimulation is turned on and off via a dedicated power switch on the 
Remote Control keypad. Simply press the stimulation on/off button 

at any time to change the stimulation status of the Stimulator. 

Signal Strength
The Remote Control 
indicates the signal strength 
between the unit and the 
Stimulator in the upper right 
corner of the display:

• If there are no signal bars, move the Remote Control closer and 

tilt it. If there are no signal bars, communication may still be 
achieved, however, it is at a very weak level. 

• If there are 1 or 2 signal bars, there is adequate communication 

between the Remote Control and the Stimulator.

• If there are 3 or 4 signal bars, the Remote Control is achieving 

optimum communication with the Stimulator.

• After missing a telemetry message, the Remote Control will dis-

play the "Searching" message. The Remote Control will then 
start looking for signal strength every second. Move to a better 
spot and wait for the signal strength to display. To cancel search-

ing press 

.