Cardo Systems ER01 ユーザーズマニュアル
scala-rider manual
DRAFT APRIL 25, 2005
Page 12 of 31
5 Getting
Started
with
the scala-rider headset
Before you can use your headset for the first time, the pairing process
between your headset and mobile phone must be completed. Pairing is
the required process of mutual recognition between your headset and
mobile phone. Please note: Your headset will not work prior to
successful completion of the pairing process!
between your headset and mobile phone must be completed. Pairing is
the required process of mutual recognition between your headset and
mobile phone. Please note: Your headset will not work prior to
successful completion of the pairing process!
5.1 Pairing
process
5.1.1 Turn on the phone and make sure its Bluetooth function is activated.
5.1.2 Press and hold the CTRL button for six seconds until the red and
5.1.2 Press and hold the CTRL button for six seconds until the red and
blue LEDs begin flashing rapidly alternating.
5.1.3 On your Bluetooth phone, search for Bluetooth devices by following
your phone’s instructions. Usually this is done by selecting the
Search or Discover option in the Bluetooth or Connection menu.
Refer to your phone’s manual for detailed instructions on how to pair
your specific phone.
Search or Discover option in the Bluetooth or Connection menu.
Refer to your phone’s manual for detailed instructions on how to pair
your specific phone.
5.1.4 After a few seconds of searching, your phone will list the “scala-rider”
as a discovered device. Select it, and when asked, follow your
phone’s instructions to accept pairing.
phone’s instructions to accept pairing.
5.1.5 When prompted by your phone, enter 0000 (4 zeros) as your PIN or
passkey.
5.1.6 Your phone will confirm when pairing has been successfully
completed.
NOTE: If pairing is not completed within two minutes, the headset will return to
Standby mode (flashing Blue every 3 seconds). To pair again, turn off the
headset by pressing and holding the CTRL button until the red led flashes three
times and repeat the process as shown above (5.1).
headset by pressing and holding the CTRL button until the red led flashes three
times and repeat the process as shown above (5.1).
Congratulations! You have now successfully completed your Bluetooth
pairing process and are able to use your scala-rider™ headset with your
mobile phone. From now on, when using your headset, you will no longer
need to pair the headset to the phone. The two devices will remain paired
until you delete that pairing from the phone.